New World Industries Inc
Controllers
New World Industries has been designing and developing controls since 2001. Having an Engineering team that has quality and innovation as a top priority insures the highest value in all of NWI’s products.
Controller
6500DC Dual 12V Motor Wireless Controller
For use with 12 volt de voltage only
The 6500DC Dual DC Motor Controller that provides RPM control for up to 2 single DC motors A up to 60AMP (Larger motor or conveyor or auger motor) and up to 40 amps to Motor B (smaller motor or spinner motor) The RPM control is done by providing the user 2 separate outputs, (3 speeds per motor low medium and full power) for each motor. The 6500DC incorporates an automatic shutdown to protect the motor and electronics.
Automatic shut down if motor is locked up. Unit will shut down for approx.30-60 seconds before you can attempt a restart.
Automatic shut off if the current draws do not drop below the rated amps after 5 to 7 seconds. Once again, the receiver will shut down for 30 to 60 seconds. You will need to investigate the problem as if you continue to override the control you will cause permanent damage to the receiver, motor or wiring.
Controller
6000DC Single 12V Motor Wireless Controller
For use with 12 volt de voltage only
The 6000DC Dual DC Motor Controller that provides RPM control for up to 1 single, DC motor up to 60AMP (Larger motor or conveyor or auger motor) and an on off circuit for a vibrator or light. The RPM control is done by providing the user 5 speed motor control in 1/5 increments. The 6000DC incorporates an automatic shutdown to protect the motor and electronics.
• Automatic shut down if motor is locked up. Unit will shut down for approx.30-60 seconds before you can attempt a restart.
• Automatic shut off if the current draws do not drop below the rated amps after 5 to 7 seconds. Once again, the receiver will shut down for 30 to 60 seconds. You will need to investigate the problem as if you continue to override the control you will cause permanent damage to the receiver, motor or wiring.
Controller
RF-5000-1 thru-8EF Wireless Controller
The RF-5000 wireless controller is a compact unit with two parts. One part is the base unit and the other piece is the keyfob or Transmitter actuator. Base units are available with 1 thru 8, VDC momentary or optional latching outputs that can be used to trigger the outputs on all of NWI’s standard line of controllers or other devices. The keyfob or 8 button Transmitter is used to send a corresponding signal to the base unit to act as a remote switching device.
These units can be ordered in a variety of configurations. With the double-pull option, the user can activate up to 8 functions that turn on a pump/motor coil simultaneously. Also available is latching circuits. This can act as an on/off switch to a component.
See wiring instructions to connect the receiver to the desired function using the color-coded wires.
Controller
RF-800 Wireless Controller
The RF-800 wireless controller is a compact unit with two parts. One part is the Receiver unit and the other piece is the Transmitter. Receiver units are available with up to 16 DC outputs that can be used to trigger the I/O’s on equipment that can be activated using DC voltage. These units can be built in various configurations. The 16-button transmitter is used to transmit a corresponding signal to the base unit or receiver.
Depending on the Receiver configuration of the remotely activated outputs, that number is reflected in the dash # suffix of the model. See suffixed coding per model showing wire colors to output function per configuration.
